APFC 711


Project Description

For temperatures of the conveyed liquid from 90°C to higher than 350°C, a small heat-stop fan is threaded on the shaft between the support and the spiral; In addition, the fan is painted with special aluminum paint suitable for high temperatures.

.
ErP : These fans are within the scope of Directive 2009/125 / EC. This law does not apply in the following cases:
- Working in potentially explosive atmospheres (ATEX)
- Operation at high temperatures (fans designed with cooling fan)
- Operation at temperatures below -40°C

- Working in toxic, corrosive or corrosive environments (use of materials such as AISI 304, AISI 316, manganese steels).
These series are centrifugal forward curved fans and therefore Ntarget = 42 is expected (Reg. UE N.327 / 2011).
Efficiency IE2 motors conforming to IEC 60034-30 are taken into account in ErP calculations.
special rate> In the case of 1.11, please note that Directive 2009/125 / CE applies, but these fans are not subject to the energy efficiency restrictions imposed and thus the verification of these parameters.

HAVA AKIMI

V = 600÷10.800 M3/SAAT

BASINÇ

PT =  320÷1.870 KG/M2

Product Technical Information

AIR FLOW 19 – 80 m3/min
INPUT PRESSURE 778 – 957 kg/m2
OUTPUT PRESSURE 850 – 1075 kg/m2
ENGINE BOARD N/A – N/A poles
INSTALLED POWER N/A KW
ROTATION SPEED 2900 rpm
SPEED LIMIT 3500 rpm
LIQUID TYPE Clean, Dusty
INLET FLANGE ⌀229mm
OUTLET FLANGE 180x125mm
WEIGHT WITHOUT MOTOR 155 Kg
SE 2 6.2 Kgm2

Use :
Fans of this series are particularly suitable for pneumatic conveying of small capacities in cement plants, air supply of cupolas, foundries and oil burners, mills, “pasta” factories, chemical, metallurgical and iron industries. medium and high pressures are required, also suitable for extracting very dusty air.

– Easy setup

– High energy saving

– Silent

– Made with high quality raw materials

– Long years of use guarantee