APF 802/A

APF 802/A


Project Description

The temperature of the sucked liquid should not exceed 80°C without cooling fan and 150°C with cooling fan.

ErP : These fans are within the scope of Directive 2009/125 / EC. This law does not apply in the following cases:

- Operation in potentially explosive atmospheres (ATEX)

- Operation at high temperatures (fans designed with cooling fan)

- Operation at temperatures below -40 °C
- Working in toxic, corrosive or corrosive environments (use of materials such as AISI 304, AISI 316, manganese steels).
These series are centrifugal forward curved fans and therefore Ntarget = 42 is expected (Reg. UE N.327 / 2011).
Efficiency IE2 motors conforming to IEC 60034-30 are taken into account in ErP calculations.
special rate> In the case of 1.11, please note that Directive 2009/125 / CE applies, but these fans are not subject to the energy efficiency restrictions imposed and thus the verification of these parameters.

AIR FLOW

V = 600÷8.400 M3/SAAT

PRESSURE

PT = 430÷1.760 KG/M2

Product Technical Information

AIR FLOW 28 – 45 m3/minute
INPUT PRESSURE 1060 – 1093 kg/m2
OUTPUT PRESSURE 1180 – 1213 kg/m2
ENGINE BOARD 160 M – 2 poles
INSTALLED POWER 15 kW
ROTATION SPEED 2950 rpm
SPEED LIMIT 3000 rpm
LIQUID TYPE Clean, Dusty
INLET FLANGE ⌀255mm
OUTLET FLANGE 200x140mm
WEIGHT WITHOUT MOTOR 220 Kg
SE 2 8.5 Kgm2

Use :
Fans of this series are particularly suitable for pneumatic conveying of small capacities in cement plants, air supply of cupolas, foundries and oil burners, mills, “pasta” factories, chemical, metallurgical and iron industries. medium and high pressures are required, also suitable for extracting very dusty air.

– Easy setup

– High energy saving

– Silent

– Made with high quality raw materials

– Long years of use guarantee