The temperature of the sucked liquid should not exceed 80°C without cooling fan and 150°C with cooling fan.
ErP : These fans are within the scope of Directive 2009/125 / EC. This law does not apply in the following cases:
- Working in potentially explosive atmospheres (ATEX)
- Operation at high temperatures (fans designed with cooling fan)
- Operation at temperatures below -40°C
- Working in toxic, corrosive or corrosive environments (use of materials such as AISI 304, AISI 316, manganese steels).
These series are centrifugal backward curved fans and therefore Ntarget = 61 is expected (Reg. UE N.327 / 2011).
Efficiency IE2 motors conforming to IEC 60034-30 are taken into account in ErP calculations.
special rate> In the case of 1.11, please note that Directive 2009/125 / CE applies, but these fans are not subject to the energy efficiency restrictions imposed and thus the verification of these parameters.
Product Technical Information
|AIR FLOW||50 – 100 m3/minute|
|INPUT PRESSURE||345 – 395 kg/m2|
|OUTPUT PRESSURE||360 – 406 kg/m2|
|ENGINE BOARD||132 M – 4-pole|
|INSTALLED POWER||7.5 kW|
|ROTATION SPEED||1450 rpm|
|WEIGHT WITHOUT MOTOR||243 Kg|
|SE 2||19 Kgm2|
Use : For suction of clean and dusty air. Such high-pressure fans are characterized by a high output, which saves electrical energy, as they have a special fan impeller mounted with reverse blades (negative).
This type of fans is particularly suitable for pneumatic conveying of small capacities in cement plants, in the air supply of cupolas in foundries and oil burners, in mills, in “pasta” factories, in the chemical, metallurgical and iron industries. medium and high pressures are required.
– Easy setup
– High energy saving
– Made with high quality raw materials
– Long years of use guarantee